Carefully slice the back part of the groove of your replacement board but leave the front part of the groove attached.
Replacing tongue and groove wood siding.
Replacing tongue and groove or wood lap siding.
Using a mallet to hold the new board use blocks of wood to protect the surface of the new tongue and groove board and cut off the back of the boards groove with a wood chisel.
Chalk and ruler for marking lines.
Tongue and groove siding is a popular building material that protects the underlying structure from weather damage.
It employs a tongue or protrusion on one edge of a board that fits into a groove or slot on an adjoining board.
Each board has a tongue side and a groove side.
Tongue and groove siding tool list.
If a small piece of your wood siding is damaged you may be able to get away with a quick replacement project.
I need to replace the lower two boards on two sides and a few pieces that are in the middle of a wall.
Insert your new board s tongue into your old board s groove and lay the new board s front groove over the other old board s tongue.
Mallet or heavy hammer.
Starting at the ceiling fit the replacement board with the damaged old board s adjacent neighbor and slip in into place.
Tongue and groove siding is an interlocking type of siding.
Ear plugs wear when using.
Easy instructions on replacing your rotten siding.
Minor repairs to tongue and groove siding can be made by patching the defects with wood filler.
If your home has wood tongue and groove boards here s a list of what you ll need to remove and replace the old sections.
Tongue and groove is a technique used to secure lumber on floors outside walls and paneling.
Replacing tongue and groove wood siding i need to do some repairs to the siding of a garage that has 6 tongue and groove wood siding.
Nails must penetrate 1 1 4 inches into solid wood.
In horizontal application start at the bottom and work up with the groove edges facing downwards.
You can use your circular saw set to the depth of just the back part of the groove.
Wider siding should be face nailed using two nails per piece.
Nail puller or hacksaw.