Resetting The Motor Stops On A Sunsetter Awning

Limit how often you open and close the awning as overuse on a hot day could cause the motor to cut out.

Resetting the motor stops on a sunsetter awning.

Motor to lose stop position settings which will require resetting the motor stop positions. From a stepladder locate the limit push buttons on the motor. Step 1 push the middle button on the remote control and unplug the awning s power cord from the electrical outlet. Resetting the limit push buttons of the sunsetter motor awnings with motors installed on the right as you face the house appendix b 2.

Unplug the power cord from the electrical outlet on the wall. Remove four 4 2 phillips screws. Press the neutral stop button on the remote. If the remote control stops working with the awning it needs to be reset.

A for 5 seconds until the motor jogs then release. A very specific problem but maybe i m not the only one. Unplug or stop using the awning and wait a few minutes. When the motor stops press and holdthe programming button on the back of the remote transmitter see fig.

The motor could be overheating. The reset process appears convoluted but when followed closely it will reconnect the remote control with the motor control unit. Plug the power cord back into the outlet. These push buttons will be on top of.

If you need to reset the motor stop position settings refer to the enclosed instructions on how to reset the motor stops.