On the options bar for overhang enter 600 and select defines slope.
Revit wall from roof to roof.
Create a sloped roof with an overhang.
Click architecture tab roof drop down roof by footprint.
After placing a wall you can override its initial top and base constraints by attaching its top or base to another element in the same vertical plane.
You can join a roof to the top face of another roof and the wall below that roof if you select the wall as the target.
But i want it to end at the roof where i painted the red line.
Create the roof opening and finish the dormer.
Create the dormer roof and join it to the main roof.
The wall must be attached to the target roof and the target roof must be a footprint roof.
By attaching a wall to another element you avoid the need to manually edit the wall profile when the design changes.
Confused by revit roofs.
Open the 02 lower parapet floor plan.
Hello i m relatively new to revit and this forum and i hope i m doing this right.
This is a general.
I hope my problem is clear when you look at the screenshot.
You cannot join a roof to more than one top face of another roof.
Move the walls to the dormer.
You will get all the answer in this short and efficient video.
Check out the complete blog post.
Thanks for the help 39377.
On the draw panel click pick walls.
My problem ist that when i make a section the outer wall goes into the roof.
In the drawing area highlight an entry wall.
Select the wall type and constraints for a dormer that will be added to a roof.
The other element can be a floor a roof a ceiling a reference plane or another wall that is directly above or below.
You can join roofs to other roofs or walls or unjoin them if they were previously joined.